Post by steve842 on Apr 14, 2016 12:06:28 GMT
Hi Nic!
I had this idea for a new way to quickly access and combine sounds but I can't figure out how to do it. I'm wondering if the stream byter might be the solution.
Typically I'm using either a Korg Taktile or a Fishman Triple Play as my midi note generator ext controller. They are both usually set up to send midi on a single midi channel (but obviously this could be changed if needed.) What I'd like to do is have a bunch of Instrument sounds/apps all set to different midi channels and be able to quickly change between them and/or combine them.
So ideally I'm envisioning up to a 16 button switchboard interface (one representing each midi channel), with each button corresponding to a different instrument/app, where you can push a hardware CC button on the Taktile or my floor controller and be able to toggle on/off whether the midi info is sent to the corresponding channel, allowing you to mix and match any of the sounds in any combination, all triggered from from a single midi note generator controller. Run-on sentence FTW!
Can the stream byter do something like this? Previously I have used presets (oops scenes) in midibridge to reroute incoming midi channels to other channels to access different sounds, but there was no way to combine them, unless there was a preset pre-configured with the combination (which would end up being too many presets to manage). Thanks in advance for any help!
I had this idea for a new way to quickly access and combine sounds but I can't figure out how to do it. I'm wondering if the stream byter might be the solution.
Typically I'm using either a Korg Taktile or a Fishman Triple Play as my midi note generator ext controller. They are both usually set up to send midi on a single midi channel (but obviously this could be changed if needed.) What I'd like to do is have a bunch of Instrument sounds/apps all set to different midi channels and be able to quickly change between them and/or combine them.
So ideally I'm envisioning up to a 16 button switchboard interface (one representing each midi channel), with each button corresponding to a different instrument/app, where you can push a hardware CC button on the Taktile or my floor controller and be able to toggle on/off whether the midi info is sent to the corresponding channel, allowing you to mix and match any of the sounds in any combination, all triggered from from a single midi note generator controller. Run-on sentence FTW!
Can the stream byter do something like this? Previously I have used presets (oops scenes) in midibridge to reroute incoming midi channels to other channels to access different sounds, but there was no way to combine them, unless there was a preset pre-configured with the combination (which would end up being too many presets to manage). Thanks in advance for any help!
