aley
Seeker
Posts: 1
|
Post by aley on Apr 3, 2024 10:47:50 GMT
Hello. I am pretty new to all of this and was hoping for some help, I am trying to trigger a pattern change in drambo when I change a pattern on the digitakt, I have midifire taking midi in from the digitakt and then i am filtering the protocol to just program change, I am then midi mapping the various patterns in drambo to a note change, I dont seem to be recieving any not change from midifire, been going around in circles for a day now. Any help would be much appreciated.
|
|
|
Post by redheronmusic on Apr 6, 2024 13:01:15 GMT
If I understand, you want to turn a program change into a note.
Program change message begins with C.
Example, program change 15, channel 1 to note 27, channel 1
If M0 == C0 0F Snd 90 1B 7F End
Depending on the board, you might have to turn off the note before it can receive the value again. In this case, add a note off with a short delay
If M0 == C0 0F Snd 90 1B 7F Snd 80 1B 00 +D100 End
Note that program changes are often listed 1-128 but MIDI values are 0-127. If you end up one off, just add or subtract 1 as needed.
|
|