|
|
Post by harable on Apr 19, 2022 20:53:56 GMT
Hi all:
I would like to convert CC2 to AT (pressure) so I can then use the Pressure Curve module*, and then convert back.
I can use
DX = BX 02
just fine, but can't do the opposite...when using
BX = DX
or
BX 02 = DX
it interprets the CC# as the Value.
What am I missing?
* is there a module to re-curve CC response?
TIA, Craig
|
|
|
|
Post by uncledave on Apr 19, 2022 21:34:25 GMT
Try
BX 02 = DX X3
That will put the CC value in the aftertouch position. Not sure how that will handle the third byte of the CC message, or if it matters.
Edit: If you mean the Pressure Curve in MidiFire, you can configure it for Note Velocity, two types of aftertouch, and Controller Value. If you just want to alter a CC value, you could use it directly; no need for messy conversion.
|
|
|
|
Post by harable on Apr 20, 2022 3:26:54 GMT
What does the 'X3' mean, and why does that accomplish what I'm after?
In any case, that's exactly what I needed (both the DX specifics, as well as the Pressure Curve info) - thanks so much!
|
|
|
|
Post by uncledave on Apr 20, 2022 12:01:43 GMT
What does the 'X3' mean, and why does that accomplish what I'm after? It puts the third byte of the CC message (the value) in the second position in the Channel Pressure output message (the pressure value). |
|
|
|
Post by harable on Apr 22, 2022 13:48:41 GMT
Okay, great, thanks.
Q re: Pressure Curve - are there any preset curves available somewhere? Drawing them in is pretty inconsistent.
|
|
|
|
Post by uncledave on Apr 22, 2022 14:42:19 GMT
Okay, great, thanks.
Q re: Pressure Curve - are there any preset curves available somewhere? Drawing them in is pretty inconsistent.
Agreed. You can use the Remap value from/to to enter specific xy pairs, but then you need to freehand draw the curve through those points. This site doesn't get many views, so I suggest that you create a new thread with the keywords "MidiFire", "Pressure Curve", and something related to installing or downloading data. That might get someone's attention better than "CC02 to AT". |
|
