Assign the same CC (both on/off) to two remote parameters

StreamByter can do almost anything.

But I am not following your question.

You first mention switching between modules. This can be done - see example at mididesigner.com/qa/9662/select-witch-midi-port-to-use-for-page-or-controller?show=9735#a9735.

Then you mention changing channels, not modules. This can be done, one of the simplest things in SB.

Can you be more specific on what you want to achieve?

Looks like the Remote Control function is hardwired so that a value greater than or equal to 64 is on, less than 64 is off.  

And looks like this is the value received at the input to MIDI Fire, not at the input to the module.  So you could not use SB to invert the value.

While you cannot use Remote control, you can make a hack, similar to the one I linked to, using SB to block or enable a module.  In this case you can use any desired value to enable or block.

At the input to the desired module, add a SB module.  From the same source, hook up a second SB module that bypasses the module.  Now we need mirror image SB block code, that toggles between the two paths.  

Put this code as in in one path, reverse the on, off, and initial values in the second module.

Now repeat for the second module, but reversing the SB module codes.


# Red Heron Music
# Sep 5, 2023
# Toggle block Rev 2

If Load
Define Ctl_Msg B0 01
Define On_Value $127 # CC Value to turn on
Define Off_Value 0 # CC Value to turn off
Ass i0 = 0  # initial state, 0 for blocked, 1 for enabled
End

If M0 == Ctl_Msg
If M2 == On_Value
Ass i0 = 1
End
If M2 == Off_Value
Ass i0 = 0
End
End

If i0 == 0
Block
End